VT-CC1101HPA-433M is based on RF Transceiver CC1101 of TI Chipcon,it's a small size and ultra low power UHF wireless module. CC1101 is a low cost true single chip UHF transmitter designed for very low power wireless applications. The circuit is mainly intended for the ISM (Industrial, Scientific and Medical) and SRD (Short Range Device) frequency bands at 315, 433, 868 and 915 MHz, The MAX RF output power can be set as high as +10dBm, with data rate as high as 500Kbps. The module integrated many RF functions and PA to make the maximum output power up to +30dBm. Customer can use it conveniently and reducing your development time.
Central frequency is 433MHz, Frequency bands :387~464MHz
Programmable output power up to +30dBm for all supported frequencies,the communication distance is above 1200m in sight .
High receiver sensitivity down to -112dBm(at 2.4Kbps data rate)
Programmable baseband modulator with GFSK/2-FSK/ASK/OOK/MSK
Programmable data rate 1.2~500Kbps
64-byte TX data FIFO
Optional Forward Error Correction with Interleaving
Support carrier sense and digital RSSI output
Low current consumption with receive mode <22mA, transmit mode at +10dBm output power <250mA
Low current consumption at power down state <2uA
Wake-on-radio functionality for automatic low-power RX polling
Integrated analog temperature sensor
Efficient SPI interface, All registers can be programmed with one "burst" transfer
Small dimension: 26.0mmu00d717.0mmu00d72.4 mm
Operating supply voltage: 3.0~3.6V DC, PA supply voltage: 3.0~3.6V DC
Product Specification / Models
Operating supply voltagetDC 3.0~3.6Vt
Central frequencyt433MHztCan be programmable to other frequency in bands
TX current consumptiont<250mAtPo=30dBm
RX current consumptiont<22mAt2.4Kbps
Application / Models
Logistics Tracking System, Warehouse patrol, Electronic label.
Replace RS232 and RS485 in data transmission
Industrial monitoring and control in data acquisition
AMR - Automatic Meter Reading
Home and building automation
Consumer Electronics products of wireless control
Wireless alarm and security systems
Wireless sensor networks
VT-BLE-S01A module base on Cypress BLE 4.2 Soc chip designed. It is designed as a peripheral module for BLE communication between devices like Smart Phone or other BLE Central devices. It offers an UART interface to connect with the Host MCU. Once the BLE connection established, it’s easy to exchange of data packet between the Host MCU and the Smart Phone.
Thanks to its ultra low power feature, the module is extremely suitable for the battery power systems. And thanks to its small size and the on board PCB antenna, the module can be easily installed in existing systems without any external circuits