1.Adjustable building scaffolding props for sale
2.Material: Q235,Q345, S235 Carbon Steel
4.Wall thickness: 1.6mm, 1.8mm,
5.Finish: painted, powder painted, electro galvanized, hot dipped galvanized
1.It is up to 15 years long life time
2.It is durable, recyclable and safety
3.Reasonable stress and large bearing capacity
4.Improve working efficiency and save labour power
5.Large and saftey operating areal
6.Keep exactly straight
7.Corrosion protection alternatives
8.Open thread and covered thread.
9.Adjustable telescopic, each having a series of maximum extended lengths and each having differing endplate configuration
Product Specification / Models
Application / Models
This shoring technique deploys rakers, or scaffolding tubes, set at an incline from the ground to the top of the wall and providing support from the side along the way. The rakers originate from a sole plate embedded in the ground and continue upward to link to a wall plate screwed into the structure near its top. Rakers should be angled at 45 degrees, though an incline of up to 75 degrees is also acceptable. Rakers must be secured at intervals with braces that bolt into cleats on the wall. Experts advise against using construction wedges to connect rakers to sole plates, because wedges can fail if the building vibrates or shakes.
This method uses shores that don't touch the ground, but rather span in midair the widths between the walls you're propping up. The flying shoring technique focuses on a horizontal strut or shore placed between the walls, secured to wall plates and supported by a network of needles, or shorter beams, and steel construction cleats. Additional inclined struts brace into wall plates and angle upward to the horizontal shore to provide additional strength. Inclined struts gain extra support from needles at the top and straining pieces, or straining sills, at the bottom.
Established in the April of 2008, Tianjin Hengfengjinda Metal Structure Co., Ltd. lies in the Jinghai Economic& Developmental Zone of Tianjin, and is an entity specializing in the manufacturing and production of various kinds of metal assembly products, architectural-use plates, and veneer boards. Our plant covers a total area of 10, 000 square meters, with a building area of 4, 200 square meters, staffing 114 employees including 10 technicians. ...